The perfect solution for the solder shy!
If you previously wanted to switch your pickups or replace electronics for higher quality, more durable components, you'd have to learn how to solder. Learning how to melt solder with a hot soldering iron about 450 degrees right next to your beautiful bass finish isn't too popular. Not only the risk of damaging your bass's finish, but damaging the components themselves! And that's before troubleshooting the electrical problems that may occur too. Needless to say, there's quite a number of bassists who choose not to solder.
This leaves these people with two options - being stuck with whatever stock electronics come in their bass, or taking them to an expensive tech to get them swapped out. The work often exceeds the price of the components themselves.
We've come up with an elegant solution to this problem. This circuit board is mounted to the back of the volume and tone potentiometers (knobs), it's pre-soldered and equipped with a screw terminal for your pickup leads. To install it all you need to do is -- Screw the washers and nuts onto the pots and jack after they're inserted into the control plate.
- Follow the labels to the left of the grey terminal to plug in each of your pickup wires into the terminal by pushing down the button and inserting the wire for the terminal to clamp it in.
This harness is made up with quality components including- CTS solid shaft shaft potentiometers
- Orange drop capacitor
- Switchcraft jack socket
Available in a variety of different options to accommodate most requirements.
We suggest the standard 250k + 0.047 with single coils and 500k + 0.022uf with humbuckers.